Installation Guide – Streamit

If you already have an existing music service:
Just replace both the network- and sound cable from your existing device to your new
Royal Streaming device, Streamit. Add the power adapter and you will be up and running. 

If you don’t have an existing music service today:
Please proceed with our simple 1-2-3 plug and play installation guide below

1-2-3, Plug and Play!

RCA

1. Start by connecting the sound cable (RCA) to Streamit ”Line out” and to your amplifier/transmitter – Red to red and white/black to white/black.

In case you have a 3,5mm sound cable today, please connect it to the sound cable adapter that you will find in your Royal Streaming package.

RCA

Sound cable adapter                  RCA cable 

2. Connect the network cable to Streamit ”Ethernet” and to your router/switch
We recommend that you contact your IT-department to ensure that intended connection is OK

3. Connect the power adapter to the Streamit ”Power (5V/12V)” and to an available outlet

The Streamit will now go through these following steps: Update check, Connecting, Buffering and at last you will see song title. SW Update might show up as well in case there’s a new firmware available. Wait until you see a song title or unknown followed by a channel name on the display – Once that happends, your music box is online and and you should hear music!

If you don´t hear music, please choose between the two options below, our FAQ-guide or contact our support for further assistance.

We´ve collected some of our most frequently asked questions below (FAQ) but in case you bump in to any problems, you’re always welcome to contact our support.

No problems to report.